Std 1 TCP/IP DPL Wireless for Hyosung

This article is intended for the confidential and exclusive use of Switch Commerce, LLC and direct customers of Switch Commerce, LLC. It is not to be reproduced or redistributed without the express written consent of Switch Commerce, LLC. Copyright © 2021. Switch Commerce, LLC. All Rights Reserved.

Supported Models

Nautilus Hyosung WINCE6.0: 1800SE, 2700, HALO, HALO-S

Required Software Version – V06.01.13 or above for the 1800SE, 2700 or Halo models.

Nautilus Hyosung WINCE5.0: 1800CE

Required Software Version – V01.04.18 or above for the 1800CE models

You MUST select a Standard 1 model on TMS.  IE. STD 1 – Halo or STD 1 – 1800se

1. Customer Setup
   • Communication
• Select Processor or Change Processor

• TCP/IP

• Message Format

• Standard 1 (Required)

• TCP/IP Type
• SSL/TLS - Enabled
• Type - Visa Framed TCP/IP
• SSL/TLS Version - Up to TLS V1.2
• EOT/ENQ Option or Visa Framed Option
• Option - No ENQ Required
• ENQ - Not Required
• EOT - Required
• Standard 1 Options
  • Terminal Status - Enabled
  • Reversal At Host Error - Enabled
  • Reason For Reversal – Enabled
  • Dynamic Flow – Enabled
  • 1st Call – Disabled
• Extended Functions

• Local Surcharge - Disabled

• Pin Change –Disabled
• Currency Conversion – Host Det.
• Currency Conversion Option – General
• Optional Function 1
  • EMV - Enabled
  • Latch - Enabled
  • AID List
  • Enable All AIDs
• EMV

Host Setup

• Host Address
  • Host Address
• Use URL - Enabled

• Host URL #1 - 192.168.0.52
• Port #1 - 8000
• Host URL #2 - 192.168.0.52
• Port #2 - 8000
• Terminal ID - NH _ _ _ _ _ _
• Routing ID – SC101
• Health Check Message - Disabled
• Key Management
  • Password #1 - Default 000000
  • Password #2 - Default 000000
    • Key Part A
  • Serial Number - 0000000000000 or Terminal Serial # (if empty)
  • Key Mode - TDES
  • Edit Key
• Secure Mode Password

• Key Index - 01

• Key Entry - A/B
• Key Part B
  • Key Entry - A/B
• Key Index - 01
1. System Setup
• Terminal IP or ATM IP Setup

Note: The customer has the choice of running the terminal on a Static IP or DHCP. If the customer does not have a need to run the terminal using static IP then DHCP will work. (The locations Internet connection may require the terminal to setup on Static IP. Static IP information must be provided by the location’s system administrator or Internet provider.)

DHCP - Enabled

or

• DHCP - Disabled (for Static IP)

Note: All Static IP information must be provided by the location’s system administrator or Internet service provider.

• IP Address - 192.168.0.55
• Subnet Mask - 255.255.255.0
• Default Gateway - 192.168.0.52

Exit out of Operator Functions, power fail the ATM, look for the welcome screen try a test transaction.