TCP/IP DPL Wireless Modem Genmega/Hantle/Tranax

This article is intended for the confidential and exclusive use of Switch Commerce, LLC and direct customers of Switch Commerce, LLC. It is not to be reproduced or redistributed without the express written consent of Switch Commerce, LLC. Copyright © 2021. Switch Commerce, LLC. All Rights Reserved.

Genmega/Hantle/Tranax

Applicable: TX-4000CE, TX-1700W

Enter, Clear, Cancel, 1, 2, 3

1. System Setup
• Serial Number
• Change Serial Number (This setup is only necessary if the terminal serial number is empty.  The terminal serial number can be found on a sticker inside the top of the atm.)
2. Customer Setup
• Change Processor
• SSL Activation - (Not necessary if SSL is activated)
• Enter SSL Activation Code
• Communication –SSL Passthrough
• Message Format - Standard 3
• Standard 3 Option
• Comm Header - Enabled
• Status Monitoring - Enabled
• 12 Seq Number - Disabled
• Use TCP/IP CRC - Disabled
3. Host Setup
• Host IP Address
• Host IP Address - 192.168.0.52
• Host Port - 8000
• Configuration - Scheduled
• Routing ID
• Change Routing ID - 123SC101
• Terminal Number
• Change Terminal # - TX_ _ _ _ _ _
• Key Management
• Enter Secure Passwords #1 & #2
• Key Mode
• TDES
• Edit Master Key
• Key Part A
• Key Index - 01
• Key Entry - A/B
• Key Part B
• Key Index - 01
• Key Entry - A/B
4. System Setup
• Device Setup
• ATM TCP/IP Setup (Terminal must be set to Static IP)
• TCP/IP Mode - Static IP
• IP Address - 192.168.0.55
• Subnet Mask - 255.255.255.0
• Default Gateway - 192.168.0.52
• Push APPLY to save changes

Exit out of Operator Functions, look for the welcome screen and try a test transaction.